Headlamps (high/low beam, for vehicles with high intensity discharge headlamps)Headlamps (high/low beam, for vehicles with high intensity discharge headlamps) - Replacement of lamp bulbs - Maintenance - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Maintenance / Replacement of lamp bulbs / Headlamps (high/low beam, for vehicles with high intensity discharge headlamps)

Do not attempt to disassemble or repair headlamps, and do not attempt to replace their bulbs.

► A high voltage is present in the power circuit and in the bulbs and bulb Warning

► A high voltage is present in the power circuit and in the bulbs and bulb terminals.
To avoid the risk of an electric shock, contact a MITSUBISHI MOTORS Authorized Service Point whenever repair or replacement is necessary.

    See also:

    Coming home light
    This function turns on the headlamps in the low beam setting for about 30 seconds after the ignition switch is turned to the “OFF” position or the operation mode is put in OFF. 1. Turn the co ...

    Deployment of front air bags
    The front air bags ARE DESIGNED TO DEPLOY when... The front air bags are designed to deploy when the vehicle suffers a moderate to severe frontal impact. Typical conditions are shown in the illus ...

    Welcome light (for vehicles equipped with the keyless entry system or the keyless operation system)
    Except for vehicles for Russia, Kazakhstan and Ukraine, this function turns on the position and tail lamps for about 30 seconds after the UNLOCK switch (A) on the remote control transmitter is pre ...