Seat belt inspectionSeat belt inspection  - Seat and seat belts - Mitsubishi Outlander Owner's Manual - Mitsubishi Outlander

● Check the belts for cuts, worn or frayed webbing and for cracked or deformed metallic parts. Replace the belt assembly if defective.

● A dirty belt should be cleaned with neutral detergent in warm water. After rinsing in water, let it dry in the shade.

Do not attempt to bleach or re-dye the belts because this affects their characteristics.

WARNING:

● We recommend you to have all seat belt assemblies including retractors and attaching hardware inspected after any collision. We recommend that seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.

● Do not attempt to repair or replace any part of the sat belt assemblies; we recommend you to have this work done by a MITSUBISHI MOTORS Authorised Service Point. Incorrect repair or replacement result in serious injury in the event of a collision.

● Once the pre-tensioner has activated, it cannot be re-used.

It must be replaced together with the retractor.

    See also:

    Rear–centre three–point seat belt
    The rear–centre three–point seat belt must be worn correctly as shown in the illustration. 1. Pull the seat belt and fit tongue (A) into the black buckle (C). 2. Push tongue (B) firmly in ...

    Passenger’s switches
    The passenger’s switches can be used to operate the corresponding passenger’s door windows. Press the switch down for operating the window, and pull up the switch for closing. Note ► ...

    Average fuel consumption
    This value shows the average fuel consumption (in L/100 km or mpg) since the display was reset. If you reset the display at the time when you want to start the measurements, average fuel consump ...