Indicator lampsIndicator lamps  - Instruments and controls - Mitsubishi Outlander Owner's Manual - Mitsubishi Outlander

warning indicator lampsTurn-signal indicator lamps/Hazard warning indicator lamps

These indicator lamps blink on and off when a turn-signal lamp is operating.

NOTE:

● If the blinking is too fast, the cause may be a blown lamp bulb or a faulty turn-signal connection.

When the hazard warning lamp switch is pressed, all turn-signal lamps will flash on and off continuously.

This indicator lamp illuminates when the high beam is used.High-beam indicator lamp

This indicator lamp illuminates when the high beam is used.

This lamp illuminates while the front fog lamps are on.Front fog lamp indicator lamp

This lamp illuminates while the front fog lamps are on.

This lamp illuminates while the rear fog lamps are on.Rear fog lamp indicator lamp

This lamp illuminates while the rear fog lamps are on.

This lamp illuminates with the lamp switch atPosition lamp indicator lamp

This lamp illuminates with the lamp switch ator  position. or Diesel preheat indicator lamp position.

This indicator lamp illuminates when the ignition switch is placed in the “ON”Diesel preheat indicator lamp

This indicator lamp illuminates when the ignition switch is placed in the “ON” position. As the glow plug becomes hot, the lamp goes out and the engine can be started.

NOTE:

● If the engine is cold, the diesel preheat indicator lamp is on for a longer time.

● When the engine has not been started within about 5 seconds after the diesel preheat indicator lamp went out, return the ignition switch to the “LOCK” position. Then, turn the switch to the “ON” position to preheat the engine again.

● When the engine is warm, the diesel preheat indicator lamp does not come on even if the ignition switch is placed in the “ON” position.

    See also:

    Lamps (room lamps, etc.) auto-cutout function (Vehicles with keyless entry system or keyless operation system)
    If any of the interior lamps are left switched on with the ignition switch in any position other than “ON” or “ACC”, it goes off automatically after approximately 30 minutes. The lamp goe ...

    To find the start of a desired track
    The start of each track on a disc can be found by using the or button (7 or 8). Track up: Press the button (8) the number of tracks to skip over. The frequency-display window will display th ...

    Mitsubishi Carisma Road Test
    Pick of the Carisma bunch has to be the 1.8 GDI. There are several models fitted with this revolutionary powerplant, and all are capable (depending on the way you drive) of either exceptional econ ...