Headlamp washer switchHeadlamp washer switch  - Instruments and controls - Mitsubishi Outlander Owner's Manual - Mitsubishi Outlander

The headlamp washer can be operated with the ignition switch in the “ON” or “ACC”

The headlamp washer can be operated with the ignition switch in the “ON” or “ACC” position and the lamp switch at the Push the button once and the washer fluid will be sprayed on to the headlamps.position.

Push the button once and the washer fluid will be sprayed on to the headlamps.

NOTE:

● If the ignition switch is in the “ON” or “ACC” position and the headlamps are on, the headlamp washer operates together with the windscreen washer the first time the windscreen washer lever is pulled.

● Check the headlamp washers periodically to confirm that the washer fluid is being sprayed properly on to the headlamp lenses.

Precautions to observe when using wipers and washers

● If the moving wipers become blocked by ice or other deposits on the glass, the motor may burn out even if the wiper switch is turned to OFF. If obstruction occurs, park your vehicle in a safe place, turn off the ignition, and clean the deposits from the glass so that the wipers operate smoothly.

● Do not use the wipers when the glass is dry.

They may scratch the glass surface and the blades wear out prematurely.

● Before using the wipers in cold weather, check that the wiper blades are not frozen onto the glass. The motor may burn out if the wipers are used with the blades frozen onto the glass.

● Avoid using the washer continuously for more than 20 seconds. Do not operate the washer when the fluid reservoir is empty.

Otherwise, the motor may burn out.

● Periodically check the level of washer fluid in the reservoir and refill if required.

During cold weather, add a recommended washer solution that will not freeze in the washer reservoir. Failure to do so could result in loss of washer function and frost damage to the system components.

    See also:

    Ignition switch turn-off reminder system
    When the ignition switch is in any position other than the “LOCK” (PUSH OFF) position, if you close all the doors and the rear hatch then try to lock the doors and rear hatch by pressing the ...

    Parking brake
    To park the vehicle, first bring in to a complete stop, fully engage the parking brake. To apply 1- Pull the lever up without pushing the button at the end of hand grip. To release 1- Pull t ...

    Headlamps (low beam, except for vehicles with high intensity discharge headlamps)
    1. For petrol-powered vehicles equipped with turbocharger, when replacing the bulb on the left side, remove the bolt (A) holding down the relay box and move the relay box towards the rear of the v ...