Safe driving techniquesSafe driving techniques  - Starting and driving - Mitsubishi Outlander Owner's Manual - Mitsubishi Outlander

Driving safety and protection against injury cannot be fully ensured. However, we recommend that you pay extra attention to the following:

Seat belts

Before starting the vehicle, make sure that you and your passengers have fastened your seat belts.

Floor mats

WARNING:

WARNING:

● Keep floor mats clear of the pedals by correctly laying floor mats that are suitable for the vehicle.

To prevent the floor mats from slipping out position, securely retain them using the hook etc.

Note that laying a floor mat over a pedal or laying one floor mat on top of another can obstruct pedal operation and lead to a serious accident.

Carrying children in the vehicle

● Never leave your vehicle unattended with the key and children inside the vehicle. Children may play with the driving controls and this could lead to an accident.

● Make sure that infants and small children are properly restrained in accordance with the laws and regulations, and for maximum protection in case of an accident.

● Prevent children from playing in the luggage compartment.

It is quite dangerous to allow them to play there while the vehicle is moving.

Loading luggage

When loading luggage, be careful not to load above the height of seats. This is dangerous not only because rearward vision will be obstructed, but also the luggage may be projected into the passenger compartment under hard braking.

    See also:

    Misting function
    Move the lever in the direction indicated by the arrow, then release, and the wipers will operate once. This function can be used when you are driving in mist or drizzle. ...

    Rear fog lamp
    1. Remove the socket and bulb assembly by turning it anticlockwise. 2. Remove the bulb by pulling it out. 3. To install the bulb, perform the removal steps in reverse. ...

    Changing the reset mode for average fuel consumption and average speed
    The mode conditions for the average fuel consumption and average speed display can be switched between “Auto reset” and “Manual reset”. 1. Press and hold the multi-information meter switch ...