Digital clockDigital clock  - For pleasant driving - Mitsubishi Outlander Owner's Manual - Mitsubishi Outlander

Automatic mode and manual mode is available for digital clock adjustment:

Automatic mode and manual mode is available for digital clock adjustment:

Select the automatic mode or the manual mode by performing the following operations:

Select the automatic mode or the manual mode by performing the following operations:

1. Press the PWR switch (A) to turn ON the audio system.

2. Enter the function setup mode by pressing the TUNE switch (B) for 2 seconds or longer.

3. Press the TUNE switch (B) repeatedly to select the CT (Clock Time) mode.

3. Press the TUNE switch (B) repeatedly to select the CT (Clock Time) mode.

The order is: AF → CT → REG → TP-S → Language of PTY display → SCV → PHONE → Function setup mode OFF (refer to “Function setup mode”, 5-52).

NOTE:

● Although “PHONE” appear on the display, the PHONE function is inoperative.

4. Turn the TUNE switch (B) left and right and select either ON or OFF.

CT ON- Automatic mode.

CT ON- Automatic mode.

CT OFF- Manual mode.

NOTE:

● After selecting a mode, you can leave the function setup mode by taking either of the following steps:

• Press the TUNE switch (B) for at least 2 seconds.

• Make no entry for 10 seconds.

Automatic mode

The automatic mode can set the local time automatically by using the signal from

The automatic mode can set the local time automatically by using the signal from the local RDS stations. In this mode, CT (A) is shown in the display. Refer to “Radio data system (RDS)”, 5-46.

Manual mode

The manual mode is also available in case the “Automatic mode” shows the incorrect time when the adjacent local RDS stations are located in a different time zone. Refer to “Radio data system (RDS)”, 5-46.

Set the time by pressing the various buttons as described below.

Set the time by pressing the various buttons as described below.

1. Keep the CLOCK button pressed until the time display flashes.

2. Press the appropriate buttons to adjust the time.

3. Once the time is set, press the “DISP” button, and the time display will stop flashing.

When a time adjustment has been made, the flashing stops automatically.

NOTE:

● If the battery cables are disconnected during repairs or for any other reason, reset the clock to the correct time after they are reconnected.

● The digital clock does not have a second display. When the “minute” display is adjusted and reset to zero, the clock begins at zero seconds for the selected minute.

“H” button - To adjust the hour.

“M” button - To adjust the minutes.

“:00” button - To reset the minutes to zero.

10:01 - 10:29...... Changes to 10:00.

10:30 - 10:59...... Changes to 11:00.

    See also:

    Limited-slip differential (LSD)
    A limited-slip differential (LSD) is applied for the rear wheel differential. The features of this LSD are described below: Just as with a conventional differential, the wheel on one side is allow ...

    SRS warning lamp/display
    Warning lamp The warning lamp/display illuminates when there is a fault with the system. In addition, the warning display will be displayed on the information screen in the multi-information di ...

    Sun visors
    1- To eliminate front glare 2- To eliminate side glare Vanity mirror Type 1 A vanity mirror is fitted to the back of the sun visor. Operating the lid of the vanity mirror will automatically tur ...