Cargo area coverCargo area cover  - For pleasant driving - Mitsubishi Outlander Owner's Manual - Mitsubishi Outlander

To use

1. Draw out the cover retracted by spring and insert it in the mounting grooves (A).

2. Remove the cover from the mounting grooves, and the cover will be rolled back

2. Remove the cover from the mounting grooves, and the cover will be rolled back into the retracted position.

NOTE:

● Do not put luggage on the cargo area cover.

To change

There are 2 installation holes (B) for the cargo area cover.

There are 2 installation holes (B) for the cargo area cover.

1. Move one of the sliders (C) toward the inside of the vehicle, and fit the

1. Move one of the sliders (C) toward the inside of the vehicle, and fit the tab (D) into the installation hole that is to be used. Move the opposite slider in the same fashion.

2. After changing the position, gently shake the entire cargo area cover to make sure it is securely retained.

NOTE:

● If the rear seat seatbacks make contact with the cargo area cover, move back the cargo area cover.

The cargo area cover could break if it supports the seatback of the rear seat.

To remove

1. Wind up the cargo area cover.

1. Wind up the cargo area cover.

2. Move one of the sliders (C) toward the inside of the vehicle and lift it to remove the cargo area cover.

To fit the cargo area cover, follow the removal steps in reverse.

Gently shake the entire cargo area cover after fitting it to make sure it is securely retained.

    See also:

    Information screen display
    Brake warning display This warning is displayed if you drive with the parking brake still applied. The warning lamp in the instrument cluster only illuminates when the parking brake is applied. ...

    Automatic transmission INVECS–II 4A/T, Sports Mode 4A/T (Intelligent & Innovative Vehicle Electronic Control System II)
    Designed for optimum control and equipped with adaptive control capabilities, the electronically controlled transmission optimally matches gear shifts to almost all driving and road conditions. C ...

    Vehicles with rain sensor
    The windscreen wipers can be operated with the ignition switch in the “ON” or “ACC” position. If the blades are frozen to the windscreen, do not operate the wipers until the ice has melte ...