Installing a child restraint system to a3-point type seat belt (with
emergency locking
mechanism)
3-point type seat belt location
The child restraint system can be fitted by using the 3-point type seat belt at the below illustrated seating position.
Installation:
1. Fasten the seat belt to secure the child restraint system.
Make sure you hear a “click” when you insert the latch plate in the buckle.
2. Use the locking clip to completely eliminate any slackness.
3. Push and pull the child restraint in all directions to be sure it is secure.
WARNING
• For some types of child restraint, the locking clip (A) should be used to help avoid personal injury during a collision or sudden manoeuvre.
It must be fitted and used in accordance with the child restraint manufacturer’s instructions.
The locking clip must be removed when the child restraint is removed.
See also:
Introduction of outside air
To introduce air into the vehicle during hot weather, set the air selection switch
(A) to the outside position and set the temperature control dial to the position
shown in the illustration. Be ...
How to adjust the tune
Manual tuning
The frequency changes every time the TUNE/SEEK button (6 or 7) is pressed. Press
the button to select the desired station.
Automatic tuning
After keeping the TUNE/SEEK button (6 or ...
Changing the momentary fuel consumption display (Type 2)
It is possible to change the bar graph setting of the momentary fuel consumption
display.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setti ...