Front passenger’s airbag OFF indication lamp
(SRS) - airbag - Seat and seat belts - Mitsubishi ASX Owner's Manual - Mitsubishi ASX" border="0" width="100" align=right>
The front passenger’s airbag OFF indication lamp is located in the instrument panel.

The indicator normally illuminates when the ignition switch is turned to the “ON” position or the operation mode is put in ON, and goes off a few seconds later.
When the front passenger’s airbag ON-OFF switch is turned OFF, the indication lamp will stay on to show that the front passenger’s airbag is not operational.
When the front passenger’s airbag ON-OFF switch is turned ON, the indication lamp goes off to show that the front passenger’s airbag is operational.
WARNING
• Do not fit any accessory that makes the indication lamp impossible to see, and do not cover the indication lamp with a sticker.
You would not be able to verify the status of the passenger airbag system.
See also:
To remove the spare tyre
1. Lift up the board.
2. To remove the spare tyre, remove the installation clamp (A) by turning it anticlockwise.
Note
► Put the spare wheel under the vehicle body near the jack. This make ...
Rear fog lamp switch
The rear fog lamp can be operated when the headlamps or front fog lamps (if so
equipped) turn on.
Push the switch to turn on the gear fog lamp, and push the switch again to turn
it off. The ind ...
Volume and tone control panel
1- PWR (On-Off) switch
2- VOL (Volume control) knob
3- Display
4- SOUND (Sound control) switch
To adjust the volume
VOL (Volume control)
Turn the VOL knob clockwise to increase the volume;
an ...
