Using the MIVEC engineUsing the MIVEC engine  - Keyless operation system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

The MIVEC engine automatically controls valve timing in accordance with driving conditions for maximum engine performance.

► To protect the engine, the high-speed mode may not be selected while the engine Note

► To protect the engine, the high-speed mode may not be selected while the engine coolant temperature is low.

11. Remove the keyless operation key from the emergency key.

► Make sure to remove the keyless operation key from the emergency key after Warning

► Make sure to remove the keyless operation key from the emergency key after the engine is started.
If not removed, the keyless operation key could fall to the floor, which could disturb the pedal operation. Furthermore, the keyless operation key could prevent the driver’s knee airbag from inflating normally or could be propelled to cause serious injury if the airbag inflates.

► If the emergency key is attached to a key holder, it may become impossible Note

► If the emergency key is attached to a key holder, it may become impossible to insert the keyless operation key into the emergency key, and it may prevent the engine from being started.

When using the emergency key to start the engine, first remove the key from the key ring.

    See also:

    Engine oil
    The engine oil used has a significant effect on the engine’s performance, service life and startability. Be sure to use oil of the recommended quality and appropriate viscosity. All engines co ...

    Deployment of side air bags
    The side air bags ARE DESIGNED TO DEPLOY when... The side air bags are designed to deploy when the vehicle suffers a moderate to severe side impact to the middle of the passenger compartment. Th ...

    Stop and tail lamps and rear turn-signal lamps
    1. Insert a straight blade (or minus) screwdriver with the end covered with a cloth or other object at the edge of the cover and pry gently to remove the cover. 2. Remove the socket and bulb asse ...