TowingTowing  - Active stability control (ASC) - Starting and driving - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

► When towing the vehicle with only the front wheels or only the rear wheels Caution

► When towing the vehicle with only the front wheels or only the rear wheels raised off the ground, do not place the ignition switch in the “ON” position. Placing the ignition switch in the “ON” position could cause the ASC to operate, resulting in an accident.
Note that the correct towing method depends on the transmission type and the vehicle’s drive configuration. For details, refer to “Towing”.

    See also:

    Wheel covers
    To removeWrap the tip of the jack bar with a cloth, insert it deeply into the notch provided in the wheel cover, and pry the cover away from the wheel. Using the same procedure at the other wheel ...

    Twin Clutch SST control mode
    Select the control mode from the following two types to suit the driving conditions. Note ► When continuously driving on closed circuit tracks or at other locations where the engine is op ...

    Twin Clutch SST control mode
    When the ignition switch is set to the “ON” position, operate the Twin Clutch SST control mode switch (A) to change the control mode. When the engine is started, the control mode is automatic ...