Removing and installing the battery upper cover (Petrol-powered vehicles equipped with turbocharger)Removing and installing the battery upper cover (Petrol-powered vehicles equipped with turbocharger) - Battery - Maintenance - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Maintenance / Battery / Removing and installing the battery upper cover (Petrol-powered vehicles equipped with turbocharger)

► Turn the ignition key to the “LOCK” position on the vehicle. Make sure that Warning

► Turn the ignition key to the “LOCK” position on the vehicle. Make sure that your clothes cannot be caught by the fan or drive belt. Personal injury could result.

To remove

1. Remove the clips (A), and then remove the air duct (B).

2. Turn the plastic nuts (C) anticlockwise, and then remove the battery upper

2. Turn the plastic nuts (C) anticlockwise, and then remove the battery upper cover (D).

Note

► Be careful not to lose the removed plastic nuts. Note

► Be careful not to lose the removed plastic nuts.

To install

1. Install the battery upper cover (A) onto the battery, and then push the plastic nuts (B) in the direction shown by the arrows to secure the cover.

Note

► Be sure to install the plastic nuts in the correct direction. Note

► Be sure to install the plastic nuts in the correct direction.
► Make sure that the battery upper cover is installed securely.

2. To install the air duct, perform the removal steps in reverse.

► Be sure to install the battery upper cover. Caution

► Be sure to install the battery upper cover.
Otherwise, the battery electrolyte may spill and cause a malfunction.
► When installing the battery upper cover, plastic nuts, and air duct, do not touch the cooling fan or other moving parts in the engine compartment. Be especially careful that the cables, your clothing or hair, etc., do not get caught in the cooling fan or other moving parts.

    See also:

    Manual transmission
    The shift pattern is shown on the gearshift lever knob. During start-up, fully depress the clutch pedal and shift into 1st gear or “R” (Reverse) position. Then gradually release the clutch peda ...

    Floor console box
    Type 1 Upper and lower boxes are located inside the floor console box. The floor console box can also be used as an armrest. 1- Upper box 2- Lower box To open the upper box, lift the right rele ...

    To play from a USB memory device
    1. Press the PWR button to turn on the audio system. The system turns on in the last mode used. 2. Connect your USB memory device to the USB input terminal. Refer to “How to connect a USB memory ...