Headlamps (high-beam, except for vehicles with high intensity discharge headlamps)
1. When replacing the bulb on the right side of the vehicle, remove the bolt (A) holding down the washer tank spout and move the spout towards the rear of the vehicle.
: Front of the vehicle
2. Turn the cap (B) anticlockwise to remove it.
: Front of the vehicle
3. Turn the bulb (C) anticlockwise to remove it.
: Front of the vehicle
4. While pressing the tab (D), pull out the bulb (E).
5. To install the bulb, perform the removal steps in reverse.
Caution
► Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is highly pressurized, so dropping, knocking,
or scratching a halogen lamp bulb can cause it to shatter.
► Never hold the halogen lamp bulb with a bare hand, dirty glove, etc. The oil from
your hand could cause the bulb to break the next time the headlamps are operated.
If the glass surface is dirty, it must be cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
See also:
Rear window wiper and washer switch (Hatchback)
The rear window wiper and washer switch can be operated with the ignition switch
at the “ON” or “ACC” position.
Rear window wiper
Turn the knob, and the rear window wiper will operate.
...
To reduce the glare
Type 1
The lever (A) at the bottom of the mirror can be used to adjust the mirror to
reduce the glare from the headlamps of vehicles behind you during night driving.
1- Normal
2- Anti-glare
Ty ...
Manual shift display
In manual shift, the currently selected gear is displayed on the multi-information
display.
...