Stop and tail lamps and rear turn-signal lampsStop and tail lamps and rear turn-signal lamps  - Rear combination lamps - Replacement of lamp bulbs - Maintenance - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

1. Insert a straight blade (or minus) screwdriver with the end covered with a cloth or other object at the edge of the cover and pry gently to remove the cover.

2. Remove the socket and bulb assemblies by turning them anticlockwise.

2. Remove the socket and bulb assemblies by turning them anticlockwise.

A- Rear turn-signal lamp

A- Rear turn-signal lamp
B- Stop and tail lamp

3. Remove the bulb by pulling it out.

4. To install the bulb, perform the removal steps in reverse.

4. To install the bulb, perform the removal steps in reverse.

► When installing the cover, make sure the arrow on the cover is pointing in Note

► When installing the cover, make sure the arrow on the cover is pointing in the direction of the front of the vehicle.

: Front of the vehicle

: Front of the vehicle

    See also:

    “Child-protection” rear doors
    1- Lock 2- Free Child protection helps to prevent doors from being opened accidentally, especially when small children are in the rear seat. A lever is provided on each rear door. If the lever i ...

    To remove the spare wheel
    1. Lift up the luggage floor board. 2. To remove the spare wheel, remove the installation clamp (A) by turning it anticlockwise. NOTE • Put the spare wheel under the vehicle body near the ja ...

    Electronic immobilizer (Anti-theft starting system)
    The electronic immobilizer has been designed to significantly reduce the possibility of vehicle theft. The purpose of the system is to immobilize the vehicle if an invalid start is attempted. A v ...