Roof drip moulding
When installing the roof carrier, remove the roof drip moulding caps.
1. Open the cover (A) and remove the screws using a Philips screwdriver.
2.
Remove the caps by sliding them.
After removal of the roof carrier, replace the roof drip moulding caps.
See also:
What to do if the following occur with the Twin Clutch SST
If there is a malfunction in the Twin Clutch SST or engine electronic control
module, the following may occur.
► Twin Clutch SST does not shift.
► Vehicle cannot move.
► Twin Cl ...
Installing a child restraint system to a 3-point type seat belt (with emergency
locking mechanism)
Installation:
1. Fasten the seat belt to secure the child restraint system. Make sure you hear
a “click” when you insert the latch plate in the buckle.
2. Remove all slack by using the locki ...
Towing with a rope
1. For vehicles with automatic transmission check the automatic transmission
fluid level. (Refer to “Automatic transmission fluid” on page 9–4.) If the fluid
level is low, transport the ve ...