Setting of door and tailgate unlock function (Except for vehicles equipped with a Dead Lock System)
The door and tailgate unlock function can be set to the following two conditions.
Each time the door and tailgate unlock function is set, a chime will sound to tell you the condition of the door and tailgate unlock function.
1. Remove the key from the ignition switch.
2. Place the combination headlamps and dipper switch in the “OFF” position, and
leave the driver’s door open.
3. Press and hold the LOCK switch (1) for 4 to 10 seconds and then also press
the UNLOCK switch (2) during this time.
4. Release in sequence the LOCK and UNLOCK switches within 10 seconds of pressing
the LOCK switch in step 3.
NOTE
• On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
See also:
Interrupt display screen (when the ignition switch or the operation mode is
OFF)
When there is information to be announced, such as lamp reminders, the buzzer
sounds and the multiinformation display switches to the warning display screen.
Refer to the appropriate page and take ...
Loading a roof carrier
Caution
► Use a roof carrier that properly fits your vehicle.
Do not load luggage directly onto the roof.
For installation, refer to the instruction manual accompanying the roof carrier.
N ...
Function setting screen
The “Display language”, “Temperature unit”, “Fuel consumption unit”, and “Average
fuel consumption and speed reset method” etc. settings can be modified as desired.
Refer to “Ch ...