Procedure for replacing the remote control switch batteryProcedure for replacing the remote control switch battery  - Keyless entry system - Locking and unlocking - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

1. Remove the screw (A) from the remote control switch.

2. With the MITSUBISHI mark facing you, insert the cloth covered tip of a straight

2. With the MITSUBISHI mark facing you, insert the cloth covered tip of a straight blade (or minus) screwdriver into the notch in the remote control switch case and use it to open the case.

NOTE

• Be sure to perform the procedure with the MITSUBISHI mark facing you. If the NOTE

• Be sure to perform the procedure with the MITSUBISHI mark facing you. If the MITSUBISHI mark is not facing you when you open the remote control switch case, the switches may come out.

3. Remove the remote control transmitter from the remote control switch case. Then, open the remote control transmitter using the method described in step 2.

4. Remove the old battery.

4. Remove the old battery.
5. Install a new battery with the + side (B) down.

6. Close the remote control transmitter firmly.

6. Close the remote control transmitter firmly.
7. Place the remote control transmitter in the remote control switch case, then securely close the remote control switch case.
8. Attach the screw (A) removed in step 1.
9. Check the keyless entry system to see that it works.

• You may purchase a replacement battery at an electric appliance store. NOTE

• You may purchase a replacement battery at an electric appliance store.
• A MITSUBISHI MOTORS Authorized Service Point can replace the battery for you if you prefer.

• When the remote control switch case is opened, be careful to keep water, CAUTION

• When the remote control switch case is opened, be careful to keep water, dust, etc. out. Also, do not touch the internal components.

    See also:

    To install
    1. Remove any foreign material in or around the connectors and ensure the vehicle seat belt is in its normal storage position. 2. Push the child restraint system’s connectors (A) into the slit (B ...

    Cargo room lamp
    1 (ON) - The lamp illuminates regardless of whether the rear hatch is open or closed. 2 - The lamp illuminates when the rear hatch is opened, and goes off when the rear hatch is closed. 3 (OFF ...

    Ignition switch
    [For vehicles equipped with keyless operation system] For information on operations for vehicles equipped with the keyless operation system, refer to “Keyless operation system: Ignition switch” ...