Keyless operation systemKeyless operation system  - Locking and unlocking - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

The keyless operation system allows you to lock and unlock the doors and tailgate, start the engine and change the operation mode simply by carrying the keyless operation key with you.

The keyless operation key can also be used as the keyless entry system remote control switch.

Refer to “Keyless operation system: Keyless entry system”.

The driver should always carry the keyless operation key. This key is necessary for locking and unlocking the doors and tailgate, starting the engine and otherwise operating the vehicle, so before locking and leaving the vehicle, be sure to check that you have the keyless operation key.

• People with implantable cardiac pacemakers or implantable cardiovascular-defibrillators WARNING

• People with implantable cardiac pacemakers or implantable cardiovascular-defibrillators should not go near the exterior transmitters (A) or the interior transmitters (B). The radio waves used by the keyless operation system could adversely affect implantable cardiac pacemakers or implantable cardiovascular-defibrillators.

WARNING

• When using electro-medical devices other than implantable cardiac pacemakers WARNING

• When using electro-medical devices other than implantable cardiac pacemakers or implantable cardiovascular-defibrillators, contact the electro medical device manufacturer ahead of time to determine the affects of radio waves on the devices.

Electro medical device operations could be affected by radio waves.

You can limit the possible operations of the keyless operation system in the following ways. (The keyless operation system can be used as a keyless entry system.) Consult a MITSUBISHI MOTORS Authorized Service Point.

• You can limit operations to locking and unlocking the doors and tailgate.
• You can limit operations to starting the engine.
• The keyless operation system can be disabled.

When keyless operation system operations are modified, the transmitters operate as follows.

• Only locking and unlocking doors or tailgate: exterior and interior transmitters
• Only starting the engine: interior transmitter

• The keyless operation key uses an ultra-weak electromagnetic wave. In the following NOTE

• The keyless operation key uses an ultra-weak electromagnetic wave. In the following cases, the keyless operation system may not operate properly or may be unstable.
• When there is equipment nearby that emits strong radio waves, such as: a power station, a radio/TV broadcasting station or an airport.
• The keyless operation system is carried together with a communications device such as a cellular phone or radio set, or with an electronic device such as a personal computer.
• The keyless operation key is touching or covered by a metal object.
• A keyless entry system is being used nearby.
• When the keyless operation key battery is worn out.
• When the keyless operation key is placed in an area with strong radio waves or noise.

In such cases, use the emergency key.

Refer to “To operate without using the keyless operation function”.

• Because the keyless operation key receives signals in order to communicate with the transmitters in the vehicle, the battery continually wears down regardless of keyless operation key use. The battery life is 1 to 3 years, depending on usage conditions. When the battery wears out, have it replaced at a MITSUBISHI MOTORS Authorized Service Point.

• Because the keyless operation key continually receives signals, strong radio wave reception could affect battery wear. Do not leave the key near a TV, personal computer, or other electronic device.

See also:

Replacement of lamp bulbs
Before replacing a bulb, ensure the lamp is off. Do not touch the glass part of the new bulb with your bare fingers; the skin oil left on the glass will evaporate when the bulb gets hot and the va ...

Speaker enrollment function
The Bluetooth® 2.0 interface can use the speaker enrollment function to create a voice model for one person per language. This makes it easier for the Bluetooth® 2.0 interface to recognise voice ...

Changing the display language
The language of the multi-information display can be switched. 1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu sc ...