Safe driving techniques
Driving safety and protection against injury cannot be fully ensured. However, we recommend that you pay extra attention to the following:
(1) Before starting the vehicle, make sure that you and your passengers have
fastened your seat belts.
(2) Never leave your vehicle unattended with the key
in the ignition and children inside the vehicle. Children may play with the driving
controls and this could lead to an accident.
(3) Make sure that infants and small
children are properly restrained in accordance with the laws and regulations, and
for maximum protection in case of an accident.
(4) Switch off the engine if you
stop for a short sleep. If the engine is left running while you sleep, unexpected
vehicle operation or other accidents may be caused by unconsciously moving the shift
lever (selector lever on automatic transmission vehicles) or pressing the accelerator
pedal. If you inadvertently keep the accelerator pedal pressed, the engine may overheat
or the engine, exhaust pipe, etc. may be abnormally overheated, resulting in an
accidental fire. If poorly ventilated, there is a risk of poisoning by exhaust gases.
(5) Prevent children from playing in the luggage compartment. It is illegal to allow
them to play there while the vehicle is moving.
(6) When loading luggage, be careful
not to load above the height of the seats. This is dangerous not only because the
rearward vision will be obstructed, but also the luggage may be projected into the
passenger compartment under hard braking.
See also:
Reversing lamps
1. Insert a straight blade (or minus) screwdriver with the end covered with a
cloth or other object into the cut out area of the cover and pry gently to remove
the cover.
2. Remove the socket a ...
To increase the set speed
There are 2 ways to increase the set speed.
“ACC RES” switch
Press and hold the “ACC RES” switch (C) while driving at the set speed, and your
speed will then gradually increase.
When you ...
Headlamp levelling switch (except for vehicles with discharge headlamps)
The angle of the headlamp beam varies depending on the load carried by the vehicle.
The headlamp levelling switch can be used to adjust the headlamp illumination
distance (when the lower beam is il ...