Changing the security alarm settingsChanging the security alarm settings - Security alarm system - Locking and unlocking - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

It is possible to set the security alarm to the “active” mode or “inactive” mode.

Follow the procedure below.

1. Except for vehicles equipped with the keyless operation system, remove the key from the ignition switch. For vehicles equipped with the keyless operation system, put the operation mode in OFF.

2. Place the lamp switch in the “OFF” position, and leave the driver’s door open.

3. Pull the windscreen wiper and washer switch towards you and hold it there.

3. Pull the windscreen wiper and washer switch towards you and hold it there. (Since the ignition switch is in the “LOCK” position or the operation mode is in OFF, washer fluid will not be sprayed.)

4. After approximately 10 seconds, the buzzer will make a sound. Keep the windscreen

4. After approximately 10 seconds, the buzzer will make a sound. Keep the windscreen wiper and washer switch pulled towards you. (If the windscreen wiper and washer switch was released, the setting change mode would be cancelled. To start over, perform the procedure again from step 3.)

5. When the buzzer stops, with the windscreen wiper and washer switch still pulled towards you, press the UNLOCK switch (A) on the remote control switch to select the security alarm settings mode.

The settings mode can be toggled by pressing the UNLOCK switch. The mode can

The settings mode can be toggled by pressing the UNLOCK switch. The mode can be confirmed from the number of times the buzzer sounds.

6. Any of the following operations can be used to terminate the system settings

6. Any of the following operations can be used to terminate the system settings change mode.

• Releasing the windscreen wiper and washer switch.
• Closing the driver’s door.
• Inserting the key into the ignition switch (except for vehicles equipped with the keyless operation system).
• Putting the operation mode in ON or ACC. (vehicles equipped with the keyless operation system)
• Placing the lamp switch in any position other than “OFF”.
• Allowing 30 seconds to pass without making any changes to the settings.

• If anything with regard to making changes to the security alarm system settings NOTE

• If anything with regard to making changes to the security alarm system settings is hard to understand, please consult your MITSUBISHI MOTORS Authorized Service Point.

• Avoid leaving valuable items inside the vehicle even when the security alarm system has been set to the “active” mode.

    See also:

    Front fog lamp switch*
    The front fog lamp can be operated when the headlamps or tail lamps turn on. Push the switch to turn on the front fog lamps, and push the switch again to turn them off. The indication lamp in t ...

    USB input terminal
    You can connect your USB memory device or iPod* to play music files stored in the USB memory device or iPod. The following explains how to connect and remove a USB memory device or iPod. Refer to ...

    To adjust height
    Adjust the head restraint height so that the centre of the restraint is as close as possible to eye level to reduce the chances of injury in the event of collision. Any person too tall for the rest ...