Cancelling the alarmCancelling the alarm  - Security alarm system - Locking and unlocking - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

It is possible to halt the activation of an alarm using the following methods:

• Pressing the LOCK or UNLOCK switch on the remote control switch.

(After pressing the LOCK switch, the vehicle will lock if all the doors and the tailgate are closed, after which the system preparation mode will once again go into effect.)

• Turning the ignition switch to the “ON” position (except for vehicles equipped with the keyless operation system).

• Putting the operation mode in ON (vehicles equipped with the keyless operation system).

• Holding the keyless operation key and locking and unlocking the doors and the tailgate using the keyless operation function (vehicles equipped with the keyless operation system).

• When the ignition switch is turned to the “ON” position or the operation mode NOTE

• When the ignition switch is turned to the “ON” position or the operation mode is put in ON, the buzzer sounds 4 times. This operation indicates that the alarm was activated while the vehicle was parked.

Please check the inside of the vehicle to confirm that nothing was stolen.

• Even if the battery is disconnected, the alarm activation memory will not be erased.

    See also:

    ACD (Active centre differential system
    The ACD is a system that improves acceleration performance and straight-ahead stability by regulating the differential limiting action and power drive distribution of the centre differential. Ca ...

    To adjust the vertical mirror position
    It is possible to move the mirror up and down to adjust its position. To adjust the mirror position It is possible to move the mirror up/down and left/ right to adjust its position. ...

    Changing the display language
    The language of the multi-information display can be switched. 1. Press and hold the multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu sc ...