3-point type seat belt (with emergency locking mechanism)
This type of belt requires no length adjustment.
Once worn, the belt adjusts itself to the movement of the wearer, but in the event of a sudden or strong shock, the belt automatically locks to hold the wearer’s body.
NOTE
• You can check if the belt locks by pulling it forward quickly.
To fasten
1. Pull the seat belt out slowly while holding the latch plate.
NOTE
• When the seat belts cannot be pulled out in a locked condition, pull the belts once forcefully and then return them. After that, pull the belts out slowly once again.
2. Insert the latch plate into the buckle until a “click” is heard.
WARNING
• Never wear the lap portion of the belt across your abdomen. During accidents it can press sharply against the abdomen and increase the risk of injury.
• The seat belts must not be twisted when worn.
3. Pull the belt slightly to adjust slackness as desired.
To unfasten
Hold the latch plate and push the button on the buckle.
NOTE
• As the belt retracts automatically, keep holding the latch plate while retracting so that the belt stows slowly. Failure to do this could damage the vehicle.
See also:
2010 Mitsubishi Outlander Review
While Mitsubishi's Outlander got a whole new front-end look for 2010, what it
really needed was a remake of its base four-cylinder engine, which is weak and
doesn't get good gas mileage, either.
...
Parking
To park the vehicle, fully engage the parking brake, and then move the gearshift
lever to 1st or “R” (Reverse) position for vehicles equipped with M/T, or set the
selector lever (CVT) or gears ...
Supplemental restraint system (SRS) - air bag
The information written in this supplemental restraint system (SRS) section contains
important points concerning the driver, front passenger, side air bags and pre-tensioner
seat belts.
The SRS a ...