Installing a child restraint system to a3-point type seat belt (with
emergency locking
mechanism)
3-point type seat belt location
The child restraint system can be fitted by using the 3-point type seat belt at the below illustrated seating position.
Installation:
1. Fasten the seat belt to secure the child restraint system.
Make sure you hear a “click” when you insert the latch plate in the buckle.
2. Use the locking clip to completely eliminate any slackness.
3. Push and pull the child restraint in all directions to be sure it is secure.
WARNING
• For some types of child restraint, the locking clip (A) should be used to help avoid personal injury during a collision or sudden manoeuvre.
It must be fitted and used in accordance with the child restraint manufacturer’s instructions.
The locking clip must be removed when the child restraint is removed.
See also:
Changing the turn-signal sound
It is possible to change the turn-signal sound.
1. Press and hold the multi-information meter switch for about 2 seconds or more
to switch from the setting mode screen to the menu screen.
Refer to ...
Washer fluid
The windscreen washer fluid reservoir is in the engine compartment.
Check the washer fluid level at regular intervals and add washer fluid to reservoir
if necessary.
Open the reservoir cap and che ...
Gas Mileage
The Lancer GT's gas mileage maxes out at an EPA-estimated 31 mpg on the
highway — a number that was merely average even back when this Lancer generation
was introduced. The smaller, more efficie ...