Seat belt inspectionSeat belt inspection - Seat and seat belts - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

• Check the belts for cuts, worn or frayed webbing and for cracked or deformed metallic parts. Replace the belt assembly if it is defective.

• A dirty belt should be cleaned with neutral detergent in warm water. After rinsing in water, let it dry in the shade. Do not attempt to bleach or re-dye the belts because this will affect their characteristics.

• We recommend you to have all seat belt assemblies including retractors and WARNING

• We recommend you to have all seat belt assemblies including retractors and attaching hardware inspected after any collision.

We recommend that seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no damage and continue to operate properly.

• Do not attempt to repair or replace any part of the seat belt assemblies; we recommend you to have this work done by a MITSUBISHI MOTORS Authorized Service Point. Incorrect repair or replacement could reduce the effectiveness of the belts and could result in serious injury in the event of a collision.

• Once the pretensioner has been activated, it cannot be re-used.

It must be replaced together with the retractor.

    See also:

    If your vehicle is stuck: in sand, mud or snow
    If the vehicle becomes stuck in snow, sand, or mud, it can often be moved by a rocking motion. Move the gearshift lever or selector lever alternately between the 1st and Reverse position (with man ...

    Instruments and controls
    1. Ventilators 2. Front passenger’s airbag OFF indication lamp 3. Gearshift or selector lever 4. Supplemental restraint system - airbag (for front passenger’s seat) 5. Front passenger’s ...

    ACD (Active centre differential system
    The ACD is a system that improves acceleration performance and straight-ahead stability by regulating the differential limiting action and power drive distribution of the centre differential. Ca ...