SRS warning lamp/displaySRS warning lamp/display  - Supplemental restraint system<span lang= (SRS) - airbag - Seat and seat belts - Mitsubishi ASX Owner's Manual - Mitsubishi ASX" border="0" width="100" align=right>

Warning lamp

The warning lamp/display illuminates when there is a fault with the system. In

The warning lamp/display illuminates when there is a fault with the system. In addition, the warning display will be displayed on the information screen in the multi-information display.

Normally, when the ignition switch is turned to the “ON” position or the operation mode is put in ON, the warning lamp should illuminate for several seconds and then should go out.

In addition, if an SRS airbag and the pretensioner system operate, the warning lamp illuminates and stays on.

The SRS warning lamp is shared by the Supplemental Restraint System (SRS) and the seat belt pretensioner system.

• When the warning lamp/display behaves as follows, the system could be faulty. WARNING

• When the warning lamp/display behaves as follows, the system could be faulty.

The SRS airbag or pretensioner seat belt might not operate normally during a collision, etc., resulting in injury, so have them inspected by a MITSUBISHI MOTORS Authorized Service Point.

• The warning lamp does not illuminate or stays illuminated when the ignition switch is turned to the “ON” position or the operation mode is put in ON.

• The warning lamp illuminates while driving.

• The warning display operates while driving.

    See also:

    Heated seats
    The heated seats can be operated with the ignition switch in the “ON” position. Operate the switch as indicated by arrows. The indication lamp (A) will illuminate while the heater is on. 1 ( ...

    Electric remote–controlled outside rear–view mirrors*
    The outside rear–view mirrors can be operated when the ignition switch is in the “ON” or “ACC” position. Place the lever (A) to the same side as the mirror whose adjustment is desired. ...

    Fuel filter indicator display
    When the ignition switch is “ON”, if more than specified limit water has accumulated in the fuel filter, a warning display is displayed on the information screen in the multi-information dis ...