Daytime dipper button (meter illumination control)
Each time you press this button, there is a sound and the brightness of the instruments changes.
NOTE
• You can adjust to 8 different levels for when the position lamps are illuminated and 8 for when they are not.
• When the lamp switch is in a position other than the “OFF” position, the meter illumination switches automatically to the adjusted brightness, depending on the brightness outside the vehicle.
• The brightness level of the instruments is stored when the ignition switch is turned to the “OFF” position or the operation mode is put in OFF.
• If you press and hold the button for longer than about 1 second when the position lamps are illuminated, the brightness level changes to the maximum level. Pressing and holding the button for longer than about 1 second again returns the brightness level to the previous level.
1- Brightness display
2- Rheostat illumination button
See also:
Keyless operation system
The keyless operation system allows you to lock and unlock the doors and tailgate,
start the engine and change the operation mode simply by carrying the keyless operation
key with you.
The keyles ...
Side turn-signal lamps
Insert a straight blade (or minus) screwdriver at the edge of the lens, remove
the socket assembly and bulb together by turning it anticlockwise, and then remove
the bulb by pulling out.
NOTE
...
To tune the radio
Automatic tuning
After pressing the SEEK button (5 or 6), a receivable station will be automatically
selected and reception of the station will begin.
Manual tuning
The frequency changes every ti ...