Information screen (when the ignition switch is turned from the “LOCK” position to the “ON” position or the operation mode is changed from OFF to ON)Information screen (when the ignition switch is turned from the “LOCK” position to the “ON” position or the operation mode is changed from OFF to<span lang= ON) - Multi-information display - Instruments and controls - Mitsubishi ASX Owner's Manual - Mitsubishi ASX" border="0" width="100" align=right>

Mitsubishi ASX / Mitsubishi ASX Owner's Manual / Instruments and controls / Multi-information display / Information screen (when the ignition switch is turned from the “LOCK” position to the “ON” position or the operation mode is changed from OFF to ON)

When the ignition switch is turned to the “ON” position or the operation mode is put in ON, the display screen switches in the following order.

1- Screen when the ignition switch or the operation mode is OFF

1- Screen when the ignition switch or the operation mode is OFF
2- System check screen
3- Screen when the ignition switch or the operation mode is ON

System check screen

When the ignition switch is turned to the “ON” position or the operation mode is put in ON, the system check screen is displayed for about 4 seconds.

If there is no fault, information screen (when the ignition switch or the operation mode is ON) is displayed.

If there is a fault, the screen changes to warning display.

Refer to “Warning display list (when the ignition switch or the operation mode is ON)”.

NOTE

• The system check screen display varies depending on the customer’s equipment. NOTE

• The system check screen display varies depending on the customer’s equipment.

Service reminder

When the time for periodic inspection arrives, the warning display is displayed for a few seconds after the ignition switch or the operation mode ON screen. Refer to “Service reminder”.

Drive mode indicator display screen

    See also:

    Obstacle detection areas
    The detection areas of the corner and back sensors are limited to those shown in the illustration. Moreover, the sensors are unable to detect low or thin objects or objects near the rear bumper. T ...

    Changing a fuse
    1. Before replacing a fuse, always turn off the electrical circuit concerned and turn the ignition key to the “LOCK” position. 2. Remove the fuse box cover. 3. Referring to the fuse load cap ...

    Caution for installing the child restraint on vehicles with a front passenger airbag
    The label shown here is attached on vehicles with a front passenger airbag. Warning ► Extreme Hazard! Do not use a rearward facing child restraint on a seat protected by an airbag in fro ...