Interrupt display screen (when the ignition switch or the operation mode is ON) ON) - Multi-information display - Instruments and controls - Mitsubishi ASX Owner's Manual - Mitsubishi ASX" border="0" width="100" align=right>
Warning display
When there is information to be announced, such as a system fault, a sound is emitted and the information screen switches to the warning display screen.
Refer to the warning list and take the necessary measures.
Refer to “Warning display list (when the ignition switch or the operation mode is ON)”.
When the cause of the warning display is eliminated, the warning display goes out automatically.
Instruments and controls
To return to the screen displayed before the warning display
Even if the cause of the warning display is not eliminated, you can return to the screen that was displayed before the warning display.
If you press the multi-information meter switch, the display screen switches to the screen that was displayed before the warning display and the mark (A) is displayed.
NOTE
• Warning display screens with mark displayed in the upper right of the screen can be switched. If you want to switch the display, press the multi-information meter switch as follows.
: Press lightly.
: Press for about 2 seconds or more.
Redisplay of a warning display screen
When the mark is displayed, if you lightly press the multi-information meter switch a few times, the warning display screen you switched from is displayed again.
Other interrupt displays
The operation status of each system is displayed on the information screen.
Refer to the appropriate page in the warning display list for further details.
Refer to “Other interrupt displays”.
See also:
Filling the fuel tank
WARNING
Gasoline is highly flammable and explosive. You could be burned or seriously
injured when handling it. When refueling your vehicle, always turn the engine off
and keep away from flames, s ...
Driver’s seat belt reminder/warning lamp and display
Warning lamp
A tone and warning lamp are used to remind the driver to fasten the seat belt.
If the ignition switch is set to the “ON” position without the driver’s seat
belt being fasten ...
To play from a USB memory device
1. Press the PWR button to turn on the audio system.
The system turns on in the last mode used.
2. Connect your USB memory device to the USB input terminal.
Refer to “How to connect a USB memory ...