Indication lamps
Turn-signal indication lamps/ Hazard warning indication lamps
These indication lamps blink in the following situations.
• When the turn-signal lever is moved to activate a turn-signal lamp.
• When the hazard warning flasher switch is pressed to activate the hazard warning
lamps.
• When the hazard warning lamps automatically activate due to sudden braking
while driving.
NOTE
• If these indication lamps blink too fast due to any operation other than sudden braking, the cause may be a blown lamp bulb or a faulty turn-signal connection.
High-beam indication lamp
This indication lamp illuminates when the high-beam is used.
Front fog lamp indication lamp
This lamp illuminates while the front fog lamps are on.
Rear fog lamp indication lamp
This lamp illuminates while the rear fog lamp is on.
Position lamp indication lamp
This indication lamp illuminates while the position lamps are on.
Diesel preheat indication lamp (diesel-powered vehicles)
This indicates the glow plug preheat condition.
[Except for vehicles equipped with keyless operation system] When the ignition switch is turned to the “ON” position, the lamp illuminates. As the glow plug becomes hot, the lamp goes out and the engine can be started.
[For vehicles equipped with keyless operation system] When the operation mode is put in ON, the lamp illuminates and preheating of the glow lamp starts automatically. As the glow plug becomes hot, the lamp goes out and the engine starts.
NOTE
• If the engine is cold, the diesel preheat indication lamp is on for a longer
time.
• When the engine is warm, the diesel preheat indication lamp does not come on
even if the ignition switch is turned to the “ON” position or the operation mode
is put in ON.
See also:
Jacking up 4-wheel drive vehicles
Warning
► Do not crank the engine while jacking up the vehicle.
The tyre on the ground may turn and the vehicle may roll off the jack. ...
Drive mode indicator display screen
This displays the 4WD status.
If you select “4WD LOCK” mode with the drive mode selector, “4WD LOCK” is displayed;
if you select “4WD AUTO” mode, “4WD” is displayed.
Nothing is d ...
Windscreen wipers
Note
► To ensure a clear rearward view, the rear window wiper will automatically perform
several continuous operations if the gearshift lever or the selector lever is put
in the “R” po ...