Coming home lightComing home light - Combination headlamps and dipper switch - Instruments and controls - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

This function turns on the headlamps in the low beam setting for about 30 seconds after the ignition switch is turned to the “OFF” position or the operation mode is put in OFF.

1. Turn the combination headlamps and dipper switch to the “OFF” or “AUTO” position (for vehicles equipped with the automatic lamp control).

2. Turn the ignition switch to the “LOCK” position or put the operation mode in OFF. Also, if a key was used to start the engine, remove the key from the ignition switch.

3. Within 60 seconds of turning the ignition switch to the “OFF” position or putting the operation mode in OFF, pull the turn signal lever towards you.

4. The headlamps will come on in the low beam setting for about 30 seconds. After

4. The headlamps will come on in the low beam setting for about 30 seconds. After the headlamps go off, the headlamps can be turned on again in the low beam setting for about 30 seconds by pulling the turn signal lever towards you within 60 seconds of turning the ignition switch to the “OFF” position or putting the operation mode in OFF.

To turn on the headlamps again after 60 seconds of turning the ignition switch to the “OFF” position or putting the operation mode in OFF, repeat the process from step 1.

• While the coming home light function is operating, perform one of the following NOTE

• While the coming home light function is operating, perform one of the following operations to cancel the function.

• Pull the lever towards you.

• Turn the combination headlamps and dipper switch to the • Turn the ignition switch to the “ON” position or put the operation mode in position.

• Turn the ignition switch to the “ON” position or put the operation mode in ON.

• It is possible to modify functions as follows:

• The time that the headlamps remain on can be changed.

• The coming home light function can be deactivated.

For further information, please contact your MITSUBISHI MOTORS Authorized Service Point.

On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.

Refer to the separate owner’s manual for details.

    See also:

    Seat belts
    To protect you and your passengers in the event of an accident, it is most important that the seat belts be worn correctly while driving. The front seat belts have a pretensioner system. These bel ...

    Cargo net*
    To use, attach the cargo net to the hooks as shown in the illustration. ...

    When turning from “LOCK” (PUSH OFF) to “ACC”
    Push the ignition switch and turn it slowly. A- Steering wheel locked B- Steering wheel released Note ► If the ignition switch does not turn from “LOCK” (PUSH OFF) to “ACC”, press ...