Reversing sensor system operation indication lamp
In case there is a malfunction in the reversing sensor system, the reversing sensor system operation indication lamp will blink and the warning buzzer will sound for approximately 5 seconds. Even after the buzzer has stopped sounding, the indication lamp will continue flashing until the system reverts to the normal state. Have the vehicle inspected at a MITSUBISHI MOTORS Authorized Service Point.
See also:
Selector lever position display
When the ignition switch is turned to the “ON” position, the position of the
selector lever is indicated in the multi-information display.
...
To remove the spare tyre
1. Lift up the board.
2. To remove the spare tyre, remove the installation clamp (A) by turning it anticlockwise.
Note
► Put the spare wheel under the vehicle body near the jack. This make ...
Interior
LHD
1. Lock switch
2. Electric remote-controlled outside rear-view mirrors switch
3. Central door lock switch
4. Electric window control switch
5. Sunshade illumination dimming control switch*
...