Steering control switch
1- Volume up button
2- Volume down button
3- SPEECH button
4- PICK-UP button
5- HANG-UP button
Volume up button
Press this button to increase the volume.
Volume down button
Press this button to decrease the volume.
SPEECH button
• Press this button to change to voice recognition mode.
While the system is in voice recognition mode, “Listening” will appear on the audio display.
• If you press the button briefly while in voice recognition mode, it will interrupt prompting and allow voice command input.
Pressing the button longer will deactivate the voice recognition mode.
• Pressing this button briefly during a call will enable voice recognition and allow voice command input.
PICK-UP button
• Press this button when an incoming call is received to answer the telephone.
• When another call is received during a call, press this button to put the first caller on hold and talk to the new caller.
• In such circumstances, you can press the button briefly to switch between callers.
You will switch to the first caller and the other caller will be put on hold.
• To establish a three-way call in such situations, press the SPEECH button to enter voice recognition mode and then say “Join calls”.
HANG-UP button
• Press this button when an incoming call is received to refuse the call.
• Press this button during a call to end the current call.
When another call is on hold, you will switch to that call.
• If this button is pressed in the voice recognition mode, the voice recognition mode will be deactivated.
NOTE
• When you press the SPEECH button to enter voice recognition mode with a cellular phone paired to the system, current information on the cellular phone, such as “remaining battery life,” “signal strength” or “roaming,” will be displayed on the audio display.* *: Some cellular phones will not send this information to Bluetooth® 2.0 interface.
• Call waiting and three-way calls can be used by the Bluetooth® 2.0 interface, only if it is possible to use those services with your cellular phone.
See also:
Operating the system in automatic mode
In normal conditions, use the system in the AUTO mode and follow these procedures:
1. Set the blower speed selection dial to the “AUTO” position.
2. Set the temperature control dial to the de ...
Interior
LHD
1. Lock switch
2. Electric remote-controlled outside rear-view mirrors switch
3. Central door lock switch
4. Electric window control switch
5. Sunshade illumination dimming control switch*
...
Manual transmission
The shift pattern is shown on the gearshift lever knob. Be sure to always fully
depress the clutch pedal before attempting to shift the lever.
CAUTION
• Do not put the gearshift lever into th ...