USB input terminalUSB input terminal  - For pleasant driving - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

You can connect your USB memory device or iPod* to play music files stored in the USB memory device or iPod.

The following explains how to connect and remove a USB memory device or iPod.

Refer to the following sections for details on how to play music files:

Refer to “To play from a USB memory device”.

*: “iPod” is a registered trademark of Apple Inc. in the United States and other countries.

How to connect a USB memory device

1. Park your vehicle in a safe place and turn the ignition switch to the “LOCK” position or put the operation mode in OFF.
2. Open the USB input terminal cover (A) in the floor console box.

3. Connect the connector cable (C) to the USB memory device (B).

3. Connect the connector cable (C) to the USB memory device (B).

4. Connect the connector cable (C) to the USB input terminal (D).

4. Connect the connector cable (C) to the USB input terminal (D).

CAUTION

• Keep the lid of the floor console box closed while driving the vehicle. CAUTION

• Keep the lid of the floor console box closed while driving the vehicle. A lid or the contents of the glove box could otherwise cause injuries.

• Do not connect the USB memory device to the USB input terminal directly. NOTE

• Do not connect the USB memory device to the USB input terminal directly.

The USB memory device may be damaged.

• When closing the floor console box, be careful not to trap the connector cable.

5. To remove the connector cable, turn the ignition switch to the “LOCK” position or put the operation mode in OFF first and perform the installation steps in reverse.

How to connect an iPod

1. Park your vehicle in a safe place and turn the ignition switch to the “LOCK” position or put the operation mode in OFF.
2. Open the USB input terminal cover (A) in the floor console box.

3. Connect the Dock connector (C) to the iPod (B).

3. Connect the Dock connector (C) to the iPod (B).

NOTE

• Use a genuine Dock connector from Apple Inc. NOTE

• Use a genuine Dock connector from Apple Inc.

4. Connect the Dock connector (C) to the USB input terminal (D).

CAUTION

• Keep the lid of the floor console box closed while driving the vehicle. CAUTION

• Keep the lid of the floor console box closed while driving the vehicle. A lid or the contents of the floor console box could otherwise cause injuries.

• When closing the floor console box, be careful not to trap the connector cable. NOTE

• When closing the floor console box, be careful not to trap the connector cable.

5. To remove the Dock connector, turn the ignition switch to the “LOCK” position or put the operation mode in OFF first and perform the installation steps in reverse.

Types of connectable devices and supported file specifications

Device types

Devices of the following types can be connected.

*: “iPod touch,” “iPod classic,” “iPod” and “iPod nano” are registered trademarks

*: “iPod touch,” “iPod classic,” “iPod” and “iPod nano” are registered trademarks of Apple Inc. in the United States and other countries.

• Depending on the type of the USB memory device or other device connected, the NOTE

• Depending on the type of the USB memory device or other device connected, the connected device may not function properly or the available functions may be limited.

• Use the iPod whose firmware has been updated to the latest version.

• You can charge your iPod by connecting it to the USB input terminal when the ignition switch or the operation mode is in ON or ACC.

• Do not keep your USB memory device or iPod in your vehicle.

• It is recommended that you back up files in case of data damage.

• Do not connect to the USB input terminal any device (hard disk, card reader, memory reader, etc.) other than the connectable devices specified in the previous section.

The device and/or data may be damaged. If any of these devices was connected by mistake, remove it after turning the ignition switch to the “LOCK” position or putting the operation mode in OFF.

File specifications

You can play music files of the following specifications that are saved in a USB memory device or other device supporting mass storage class.

Sun visors

    See also:

    Radio data system (RDS)
    1- PWR (On-Off) switch 2- AM/FM (FM/MW/LW selection) button 3- Memory select buttons 4- TP (Traffic program) button 5- PTY (Program type) button 6- TUNE switch 7- SEEK (Up-seek) button 8- S ...

    Procedure for replacing the remote control switch battery
    1. Remove the screw (A) from the remote control switch. 2. With the MITSUBISHI mark facing you, insert the cloth covered tip of a straight blade (or minus) screwdriver into the notch in the remot ...

    Function setting screen
    The “Display language”, “Temperature unit”, “Fuel consumption unit”, and “Average fuel consumption and speed reset method” etc. settings can be modified as desired. Refer to “Ch ...