Cigarette lighterCigarette lighter - For pleasant driving - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

The cigarette lighter can be used while the ignition switch or the operation mode is in ON or ACC.

1- Push all the way in.

1- Push all the way in.

The cigarette lighter will automatically return to its original position with a “click” when ready. Pull it out for use.

After use, insert the cigarette lighter to its original position in the socket.

• Do not leave the cigarette lighter removed from its socket, because the socket NOTE

• Do not leave the cigarette lighter removed from its socket, because the socket might become clogged by foreign material and be short-circuited.

• Do not touch the heating element or the cigarette lighter housing, hold CAUTION

• Do not touch the heating element or the cigarette lighter housing, hold the knob only to prevent burns.

• Do not allow children to operate or play with the cigarette lighter as burns may occur.

• Something is wrong with the cigarette lighter if it does not pop back out within approximately 30 seconds of being pushed in.

Pull it out and have the problem corrected at MITSUBISHI MOTORS Authorized Service Point.

• Do not use any electric appliance that is not approved by MITSUBISHI MOTORS. Doing so could damage the socket. If you used the cigarette lighter after damaging the socket, the cigarette lighter might pop out or fail to come out after being pushed in.

• When the cigarette lighter socket is used as a power source for an electric appliance, be sure that the electric appliance operates at 12 V and has an electric capacity of 120 W or less. In addition, long use of the electric appliance without running the engine may run down the battery.

    See also:

    2013 Mitsubishi Lancer Review
    In a segment defined by value and gas mileage, the sporty Lancer GT doesn't cut it against its best competitors — or even against the average ones. Though you wouldn't know just by looking, the ...

    System armed mode
    (The buzzer stops and the security indicator continues to blink with indicator’s reduced lit-up duration time.) Once the system preparation mode has ended, the system armed mode starts. If an u ...

    Auto stop
    1. Stop the vehicle. 2. Place the gearshift lever in the “N” (Neutral) position. 3. Release the clutch pedal. 4. The “ ” display/indicator will turn on and the engine will stop automatica ...