Accessory socketAccessory socket  - For pleasant driving - Mitsubishi ASX Owner's Manual - Mitsubishi ASX

• Be sure to use a “plug-in” type accessory operating at 12 V and at 120 W CAUTION

• Be sure to use a “plug-in” type accessory operating at 12 V and at 120 W or less.

When using more than one socket at the same time, make sure that the electrical accessories are 12 V accessories and that the total power consumption does not exceed 120 W.

• Long use of the electric appliance without running the engine may run down the battery.

• When the accessory socket is not in use, be sure to close the lid or install the cap, because the socket might become clogged by foreign material and be short-circuited.

To use a plug-in type accessory, open the lid or remove the cap, and insert the plug in the accessory socket.

• Accessory sockets in 2 locations can be used at the same time. NOTE

• Accessory sockets in 2 locations can be used at the same time.

The accessory socket can be used while the ignition switch or the operation mode is in ON or ACC.

Interior lamps

    See also:

    Replacement of lamp bulbs
    Before replacing a bulb, ensure the lamp is off. Do not touch the glass part of the new bulb with your bare fingers; the skin oil left on the glass will evaporate when the bulb gets hot and the va ...

    Heater
    The heater can only be used while the engine is running. ...

    Odometer/Tripmeter
    When the ignition switch is turned “ON”, the odometer display is given in the lower display window (1). The upper display window (2) shows the tripmeter A and tripmeter B distances in that s ...