Wheel covers
To removeWrap the tip of the jack bar with a cloth, insert it deeply into the notch provided in the wheel cover, and pry the cover away from the wheel. Using the same procedure at the other wheel cover notches, work the wheel cover away from the wheel to remove it completely.
CAUTION
• Removing the cover with your hands may cause injury to the fingers.
NOTE
• The wheel cover is made of plastic. Pry it loose carefully.
To install
1. Make sure the tabs (A) of the back of the wheel cover are not broken and correctly fitted on the rings (B). If in doubt, do not install the wheel cover and consult a MITSUBISHI MOTORS Authorized Service Point.
2. Align the tyre valve stem (C) with the cut out area (D) in the wheel cover.
NOTE
There is a symbol (E) on the back of the wheel cover indicating the cut out area.
3. Push the underside (F) of the wheel cover into the wheel.
4. Gently push both sides (G) of the wheel cover and hold them in place with
both knees.
5. Gently push around the top (H) of the wheel cover.
See also:
Voice recognition function
The Bluetooth® 2.0 interface is equipped with a voice recognition function.
Simply say voice commands and you can perform various operations and make or
receive hands-free calls.
With the Bluetoo ...
On a bumpy or rutted road
Drive as slow as possible when driving on bumpy or rutted roads.
Caution
► The impact on tyres and/or wheels when driving on a bumpy or rutted road
can damage the tyre and/or wheel.
► ...
ECO mode indicator (for vehicles equipped with CVT or Twin clutch SST)
Except for vehicles for Russia, Kazakhstan and Ukraine, this indicator will be
displayed when fuel-efficient driving is achieved. ...