Installing a child restraint system to a 3–point type seat belt (with emergency locking mechanism)
For safety, you are advised to install the child restraint system using a 3–point type seat belt with emergency/automatic locking mechanism. If you cannot avoid installing it using another type of seat belt, follow the instructions given below.
Installation:
1. Fasten the seat belt to secure the child restraint system. Make sure you hear
a ”click” when you insert the latch plate in the buckle.
2. 3–point type seat
belts require no length adjustment. Remove all slack by using the locking clip.
3. Push and pull the child restraint in all directions to be sure it is secure.
CAUTION
For some type of child restraint, the locking clip (A) should be used to help avoid personal injury during a collision or sudden manoeuvre. It must be fitted and used in accordance with the child restraint manufacturer’s instructions. The locking clip must be removed when the child restraint is removed.
See also:
Cancelling the alarm
It is possible to halt the activation of an alarm using the following methods:
• Pressing the LOCK or UNLOCK switch on the remote control switch.
(After pressing the LOCK switch, the vehicle will ...
Floor console box
Type 1
Upper and lower boxes are located inside the floor console box.
The floor console box can also be used as an armrest.
1- Upper box
2- Lower box
To open the upper box, lift the right rele ...
Misting function
Move the lever in the direction indicated by the arrow, then release, and the
wipers will operate once.
This function can be used when you are driving in mist or drizzle. ...