Turn/lane-change signals
The turn-signal lamps flash when the switch is operated (with the ignition switch “ON”). At the same time, the turn signal indicator flashes.
1- Turn-signals
When making a normal turn, use position (1). The lever will return automatically when cornering is completed. There are times when the lever will not return after cornering. This occurs when the steering wheel is turned only slightly. In such cases, return the lever by hand.
2- Lane-change signals
When changing lanes, use position (2). It will return to the neutral position when released.
NOTE
If the lamp flashes unusually quickly, the bulb in a turn–signal lamp may have burned out. Have the vehicle inspected by an authorized MITSUBISHI dealer.
See also:
Braking
All the parts of the brake system are critical to safety.
We recommend you to have the vehicle checked at regular intervals according to
the service booklet.
CAUTION
• Avoid driving habits tha ...
Older children
Children who have outgrown the child restraint system should be seated in the
rear seat and wear combination lap shoulder belt.
The lap portion of the belt should be snug and positioned low on the ...
To listen to the radio
1- PWR (On-off) switch 2- VOL (Volume control) knob 3- U/M/L (UKW/MW/LW selection)
button 4- Audio adjust button 5- AUDIO button 6- TUNE/SEEK (Down-step/Down-seek)
button 7- TUNE/SEEK (Up-step/U ...