Display unit selection
Originally, km/h and L/100 km are selected. When you want to select the unit “mile”, follow this procedure.
NOTE
For vehicles without MITSUBISHI genuine audio system, only the unit of average fuel consumption can be changed to km or miles as you like.
1. Press the “M” button while pressing the button (A) to activate the display unit selection function. The currently selected unit will appear.
2. Use the “H” or “M” button to select the desired speed unit, then press the “SET” button to enter the setting.
H- km
M- mile
3. If the km unit was selected in step 2, the fuel consumption unit must be selected continuously using the “H” or “M” button. The currently selected unit will appear.
Use the “H” or “M” button to select the desired fuel consumption unit, then press the “SET” button to enter the setting.
H- L/100 km
M- km/L
4. Press the “SET” button to determine the setting. The display will return to the original display item.
NOTE
(1) For vehicles without a MITSUBISHI genuine audio system, only the unit
of fuel consumption can be changed to km or miles as you like.
(2) If you select
“M” (mile) unit in step 2, fuel consumption is automatically shown in “mpg (mile
per gallon)”.
(3) To cancel the unit setting procedure before completion, press
the button (A).
(4) The outside temperature and clock are not shown during the
unit selecting procedure.
(5) If the “SET” button is not pressed for about 15
seconds or longer in the middle of the selection, the currently selected unit is
set automatically. Then, the display returns to the original display item.
See also:
Connecting the Bluetooth® 2.0 interface and Bluetooth® device
Before you can make or receive hands-free calls or play music using the Bluetooth®
2.0 interface function, you must pair the Bluetooth® device and Bluetooth ® 2.0
interface.
Note
► Pai ...
System characteristics
The principle of the Auto Stop & Go (AS&G) system is that it adapts to the vehicle’s
needs (i.e. energy supply). This means that in certain circumstances the engine
will not stop and in ...
Daytime dipper button (meter illumination control)
Each time you press this button, there is a sound and the brightness of the instruments
changes.
NOTE
• You can adjust to 8 different levels for when the position lamps are illuminated
and 8 ...