To resume set speed
If the vehicle speed remains 40 km/h or higher when the auto–speed control is deactivated by operating the auto–speed control lever or by any one of the (2) to (7) conditions noted above, the previously set speed can be automatically resumed by pulling up the auto–speed control lever.
See also:
If the DPF warning display illuminates during vehicle operation
Steady illumination of the DPF warning display shows that the DPF has not been
able to burn away all of the trapped PM and that, as a result, an excessive amount
of PM has accumulated inside it. T ...
At extreme cold ambient temperature
If the engine won’t start, depress the accelerator pedal about halfway while
cranking the engine. Once the engine starts, release the accelerator pedal.
CAUTION
When starting the engine, make su ...
Setting the system
1. Turn the ignition switch to the “LOCK” position.
Also, if a key was used to start the engine, remove the key from the ignition
switch.
2. Get out of the vehicle. Close all doors and rear ha ...