How to enter frequencies in the memory
Manual setting
You can assign to the memory select buttons (8) a maximum of 12 stations in the UKW band (6 U1 stations and 6 U2 stations), 6 stations in the MW band and 6 stations in the LW band. (Stations already assigned to the memory select buttons are replaced by any newly assigned stations.)
Follow the steps described below.
1. Press either the TUNE/SEEK button (6 or 7) to tune the frequency to be entered
in the memory.
2. Press one of the memory select buttons (8) for about 2 seconds
or longer. The sound will be momentarily interrupted while the frequency is being
entered into the memory.> The number of the button corresponding to the entry in
the memory and the frequency are displayed.> 3. The preset memory setting is retrieved
by pressing the button and then releasing it within 2 seconds.
Automatic setting
With the method, all manually set stations in the band currently selected for reception are replaced with stations in the same band that are automatically selected in order of signal strength. The radio automatically selects 12 stations in the UKW band and 6 stations each in the MW and LW band.
Follow the steps described below.
1. With the radio mode selected, hold down the U/M/L button (3) until a beep
is emitted. The 6 stations with the best signal strength will automatically be assigned
to the memory select buttons (8), with the lowest-frequency station being assigned
to the lowestnumber button.
2. When you subsequently press a memory select button
to select a channel number, the radio will begin receiving the station assigned
to that number.
See also:
Procedure for replacing the remote control switch battery
1. Remove the screw (A) from the remote control switch.
2. With the MITSUBISHI mark facing you, insert the cloth covered tip of a straight
blade (or minus) screwdriver into the notch in the remot ...
Reversing sensor system operation indication lamp
In case there is a malfunction in the reversing sensor system, the reversing
sensor system operation indication lamp will blink and the warning buzzer will sound
for approximately 5 seconds. Even ...
Security alarm system
The security alarm system is for alerting the surrounding area of suspicious
behaviour to prevent unlawful entry into the vehicle by operating an alarm if a
door, the tailgate or the bonnet is ope ...