Audio system anti-theft feature
To prevent theft of the audio system, the control panel can be removed. Always remove the control panel when you leave the vehicle.
Removing the control panel
Turn the ignition switch to the OFF position. Then slide the release button (A) to the left and remove the control panel from the audio system. (When sliding the release button, place one hand on the control panel to prevent it from falling out.) The lamp (B) will start flashing.
Insert the control panel into the latches at the right-hand side of the cutout on the audio system. Then, press the left-hand side of the control panel into the cutout until it locks in position. The lamp (B) will stop flashing. Next, turn the ignition switch to the ON position.
NOTE
(1) Do not leave the control panel in any place where it may become hot (for
example, the dashboard) or in any place where it may become wet.
(2) If you lose
the control panel, contact an authorized MITSUBISHI dealer.
See also:
To adjust the mirror position
The outside rear-view mirrors can be operated when the ignition switch is in
the “ON” or “ACC” position.
Warning
► Do not attempt to adjust the rear-view mirrors while driving. This ...
During cold weather
To ensure proper operation of the washers at low temperatures, use a fluid containing
an anti–freezing agent. ...
Parking brake break-in
Break-in the parking brake linings whenever the brake performance of the parking
brake is insufficient or whenever the parking brake linings and/or discs are replaced,
in order to assure the best ...