Chassis and underbody protection
Your vehicle’s underbody has been treated at the factory in order to protect it from rust and corrosion. Some areas have been injected with anti-corrosion agents and wax. The effectiveness of these measures, however, will be reduced by flying stones, road chemicals, etc., as the vehicle is driven. You should take your vehicle to your authorized MITSUBISHI dealer every 12 months to have body sheet metal inspected for condition, and it is recommended to have the underbody checked regularly (autumn and spring) and have additional protection treatment carried out as required.
As not all of the commercially available materials are suitable for use on your vehicle, it is recommended that you have this work carried out by an authorized MITSUBISHI dealer.
When washing the vehicle, especially in winter, spray the underbody with water to remove dirt and dust which might contain salts, road chemicals, etc.
See also:
Additional equipment (For regions where snow is encountered)
It is a good idea to carry a shovel or a short-handled spade in the vehicle during
the winter so that you can clear away snow if you get stranded. A small hand-brush
for sweeping snow off the vehi ...
Steering wheel height adjustment
1. Release the tilt lock lever while holding the steering wheel up.
2. Adjust the steering wheel to the desired height.
3. Securely lock the steering wheel by pulling the tilt lock lever fully upwar ...
Manual transmission
The shift pattern is shown on the gearshift lever knob. During start-up, fully
depress the clutch pedal and shift into 1st gear or “R” (Reverse) position.
Then gradually release the clutch peda ...