What to do if the engine speed becomes unstable after the battery is replaced
If the engine speed becomes unstable after the battery is replaced, reset the engine using the following method:
1. Stop the vehicle in a safe place.
2. Place the gearshift lever (manual transmission)
in the ”N” (Neutral) or the selector lever (automatic transmission) in the ”P” (PARK)
position. Stop the engine.
3. Restart the engine.
4. Turn off the air conditioning
(if so equipped).
5. Allow the engine to warm up until the needle in the water
temperature gauge stabilizes near the centre of the gauge.
6. Stop and restart
the engine.
7. Allow the engine to idle for approximately 10 minutes.
8. When
the engine speed stabilizes, the resetting procedure is complete.
NOTE
If the engine speed remains unstable after the resetting procedure has been performed, have the vehicle inspected by an authorized MITSUBISHI dealer.
See also:
Digital clock
Automatic mode and manual mode is available for digital clock adjustment.
Select the automatic mode or the manual mode by performing the following operations:
A- PWR switch
B- TUNE switch
1. Pre ...
Roof carrier mounting brackets
When installing the roof carrier, use the brackets (A).
The brackets (A) are located under each cover (B).
Attaching the roof carrier
Slide each cover (B) towards the front of the vehicle to remo ...
To recline the seatback
Adjust the seatback angle by turning the dial.
1- To move to forward direction 2- To recline rearward
WARNING
To minimize the risk of personal injury in the event of a collision or
sudden braki ...