Side turn-signal lamps

Insert a straight blade (or minus) screwdriver at the edge of the lens, remove the socket assembly and bulb together by turning it anticlockwise, and then remove the bulb by pulling out.
NOTE
Wrap a piece of cloth around the straight blade (or mines) screwdriver in order to avoid scratching the lens and the body.
See also:
Warning lamps
Brake warning lamp
This lamp illuminates when the ignition switch is turned to the “ON” position
or the operation mode is put in ON, and goes off after a few seconds.
Always make sure that t ...
During cold weather
The capacity of the battery is reduced at low temperatures. This is an inevitable
result of its chemical and physical properties. This is why a very cold battery,
particularly one that is not full ...
Service reminder
Displays the approximate time until the next periodic inspection that MITSUBISHI
MOTORS recommends.
“---” is displayed when the inspection time has arrived.
Note
► Depending on the veh ...
