Engine coolant
A translucent coolant reserve tank is located in the engine compartment. The coolant level in this tank should be kept between the two marks on the reserve tank when measured while the engine is cold. The cooling system is a closed system and normally the loss of coolant should be very slight. A noticeable drop in the coolant level could indicate leakage. If this occurs, have the system checked at an authorized MITSUBISHI dealer as soon as possible.
If the level should drop below the ”LOW” level on the reserve tank, open the lid and add coolant.
Also, if the reserve tank is completely empty, remove the radiator cap and add coolant until the level reaches the filler neck.
NOTE
On diesel–powered vehicles, the radiator has no filler port. Supply coolant from the filler port in the reserve tank.
WARNING
Do not open the reserve tank lid or radiator cap while the engine is hot. The coolant system is under pressure and any hot coolant escaping could cause severe burns.
See also:
Used engine oils safety instructions and disposal information
Warning
► Prolonged and repeated contact may cause serious skin disorders, including
dermatitis and cancer.
► Avoid contact with the skin as far as possible and wash thoroughly after ...
Rheostat (meter illumination control)
The rheostat can be adjusted while the lamp switch is “”
or “”. Turn the dial to adjust the meter
illumination to the desired brightness.
1- To increase brightness 2- To reduce brightne ...
Parking
To park the vehicle, first bring it to a complete stop, fully engage the parking
brake and then move the selector lever to the “P” (PARK) position.
If you are going to leave the vehicle unatten ...