Exterior and interior lamp operation
Operate the combination lamp switch to check that all lamps are functioning properly. If the lamps do not illuminate, the probable cause is a blown fuse or defective lamp bulb. Check the fuses first. If there is no blown fuse, check the lamp bulbs.
For information regarding the inspection and replacement of the fuses and the lamp bulbs, refer to the section entitled “For emergencies”.
If the fuses and bulbs are all OK, take the vehicle to an authorized MITSUBISHI dealer for inspection and repair.
See also:
Selector lever operation
The CVT selects an optimum gear ratio automatically, depending on the speed of
the vehicle and the position of the accelerator pedal.
The selector lever (A) has 2 gates; the main gate (B) and the m ...
Electronically controlled 4WDsystem
The electronically controlled 4WD system is a 4- wheel drive system that allows
one of three drive modes to be selected with a dial, in accordance with the driving
conditions.
The following drive ...
Towing bar mounting specifications
See the following table for fixing points (A) for the towing bar.
...