Wiper blades
If the blades are frozen to the window glass, do not operate the wipers until the ice has melted and the blades are freed, otherwise the wiper motor may be damaged.
Wiper blade rubber replacement
1. Lift the wiper arm off the window glass.
2. Pull the wiper blade until its
stopper (A) disengages from the hook (B). Then, pull the wiper blade further to
remove it.
NOTE
Do not allow the wiper arm to fall onto the window glass; it could damage the glass.
3. Attach retainers (C) to a new wiper blade.
4. Insert the wiper blade into
the arm, starting with the opposite end of the blade from the stopper. Make sure
the hook (B) is fitted correctly in the grooves in the blade.
NOTE
If retainers (C) are not supplied with the new wiper blade, use the retainers from the old blade.
5. Push the wiper blade until the hook (B) engages securely with the stopper (A).
See also:
Selector lever position display screen (vehicles with CVT)/ Gearshift lever
position display screen (vehicles with Twin Clutch SST)
Shows the position of the selector lever or gearshift lever.
Refer to “Selector lever operation”.
Refer to “Gearshift lever position display”. ...
Fuel gauge
The fuel gauge indicates the fuel level in the fuel tank irrespective of the
ignition switch position.
0- Empty 1- Full
CAUTION
Do not drive with an extremely low fuel level; running out of fue ...
Emergency starting
If the engine cannot be started because the battery is weak or dead, the battery
from another vehicle can be used with jumper cables to start the engine.
WARNING
• To start the engine using jum ...