Procedure for replacing the remote control switch batteryProcedure for replacing the remote control switch battery - Keyless entry system - Locking and unlocking - Mitsubishi Lancer Owner's Manual - Mitsubishi Lancer

Mitsubishi Lancer / Mitsubishi Lancer Owner's Manual / Locking and unlocking / Keyless entry system / Procedure for replacing the remote control switch battery

1. Before replacing the battery, remove static electricity from your body by touching a metal grounded object.
2. Remove the screw (A) from the remote control switch.

3. With the MITSUBISHI mark facing you, insert the clothcovered tip of a straight

3. With the MITSUBISHI mark facing you, insert the clothcovered tip of a straight blade (or minus) screwdriver into the notch in the remote control switch case and use it to open the case.

Note

► Be sure to perform the procedure with the MITSUBISHI mark facing you. If Note

► Be sure to perform the procedure with the MITSUBISHI mark facing you. If the MITSUBISHI mark is not facing you when you open the remote control switch case, the switches may come out.

4. Remove the remote control transmitter from the remote control switch case. Then, open the remote control transmitter using the method described in step 3.

5. Remove the old battery.

5. Remove the old battery.
6. Install a new battery with the + side (B) down.

7. Close the remote control transmitter firmly.

7. Close the remote control transmitter firmly.
8. Place the remote control transmitter in the remote control switch case, then securely close the remote control switch case.
9. Attach the screw (A) removed in step 2.
10. Check the keyless entry system to see that it works.

► You may purchase a replacement battery at an electric appliance store. Note

► You may purchase a replacement battery at an electric appliance store.
► A MITSUBISHI MOTORS Authorized Service Point can replace the battery for you if you prefer.

► When the remote control switch case is opened, be careful to keep water, Caution

► When the remote control switch case is opened, be careful to keep water, dust, etc. out. Also, do not touch the internal components.

    See also:

    Changing the security alarm settings
    It is possible to set the security alarm to the “active” mode or “inactive” mode. Follow the procedure below. 1. Except for vehicles equipped with the keyless operation system, remove the ...

    Driver’s switches
    The driver’s switches can be used to operate all door windows. A window can be opened or closed by operating the corresponding switch. Press the switch down to open the window, and pull up the sw ...

    Fuel injection amount learning process (diesel-powered vehicles)
    To keep exhaust emissions and engine noise low, the engine very occasionally performs a learning process for the fuel injection amount. The engine sounds slightly different from usual while the lea ...