Locking the doors and rear hatch
When you are carrying the keyless operation key, if you press the driver’s or front passenger’s door lock/unlock switch (A), or the rear hatch LOCK switch (B) within the operating range, the doors and the rear hatch are locked.
The turn-signal lamps will blink once.
Also refer to “Locking and unlocking: Doors, Central door locks, Rear hatch” on pages 1-26, 1-27 and 1-32.
Note
► For vehicles equipped with the mirror retractor switch, the outside rear-view mirrors automatically retract when all the doors and the rear hatch are locked using the keyless operation function.
Refer to “Starting and driving: Outside rearview mirrors”.
► With a vehicle that has a Dead Lock System, pressing the driver’s or front passenger’s door lock/unlock switch (A), or the rear hatch LOCK switch (B) two times in succession causes the Dead Lock System to be set.
(Refer to “Setting the system”.)
► The keyless operation function does not operate under the following conditions:
• The keyless operation key is
inside the vehicle.
• A door or the rear hatch is open or ajar.
• The ignition switch is not in the “LOCK” position.
• The emergency key is in the ignition switch.
► When checking if the vehicle is locked, press the rear hatch OPEN switch within about 3 seconds of locking the vehicle. If you wait longer than 3 seconds and press the rear hatch OPEN switch, the doors and rear hatch will be unlocked.
► The time allowed for checking that the vehicle is locked can be adjusted. For further information, please contact a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with MITSUBISHI Multi-Communication System (MMCS), screen operations can be used to make the adjustment.
Refer to the separate owner’s manual for details.
See also:
To adjust height
Adjust the head restraint height so that the centre of the restraint is as close
as possible to eye level to reduce the chances of injury in the event of collision.
Any person too tall for the rest ...
To reduce the set speed
There are 2 ways to reduce the set speed.
Auto–speed control lever
Pull down and hold the auto–speed control lever until you reach the lower speed
you want. Release the lever when the desire ...
Parking with the engine running
Never leave the engine running while you take a short sleep/rest, or you open
or close a gate or garage door, etc. Also, never leave the engine running in a closed
or poorly ventilated place.
Wa ...